Electronic hand brake module installation instructions
Step 1 Check the degree of wear on the handbrake. If the wear is serious, check if the hand brake skin is less than 50%. It is recommended to replace the handbrake. (Note: "Handbrake skin" is not a foot brake skin)
Step 2 When loading, the power plug cannot be inserted first.
Step 3 first install two large left and right hand brakes, the wheel is installed
Step 4 Install the left and right side pull wires to the tightest, then reverse the loose 3 to 4 times.
Step 5 Finally plug in the plug and put the car down. Start the brake, press the hand brake switch
Step 6 there is a code to use the computer to clear it.
1. Do not pull the emergency unlocking line at any time unless the handbrake module is damaged, cannot be removed, pull the emergency unlocking line, and after hearing the sound of "", the handbrake computer cannot be used any more.
2. Remember! Install the brake pads inside the wheels on both sides and tighten them a bit.
3. Be sure to pull the cable on both sides of the handle and then plug it in, then start the car. Never connect the plug directly, so that the hand brake will be hung inside.
Profession installation Note:
Please first link to the wires then link to the power，otherwise it would be broken when installation，thanks.
Parking Brake Actuator With Control Unit
for 2007-2013 X5 E70
for 2008-2014 X6 E71 E72
Model Submodel Engine
E70 X5 M57 3.0L
E70 X5 N52 3.0L
E70 X5 N55 3.0L
E70 X5 N62 4.8L
E70 X5 S63 4.4L
E70 X5 M S63 4.4L
E70 X5 xDrive30i N52 3.0L
E70 X5 xDrive35d M57 3.0L
E70 X5 xDrive35i N55 3.0L
E70 X5 xDrive48i N62 4.8L
E70 X5 xDrive50i N63 4.4L
E71 X6 S63 4.4L
E71 X6 35iX N54 3.0L
E71 X6 50iX N63 4.4L
E71 X6 50iX S63 4.4L
E71 X6 ActiveHybrid N63 4.4L
E71 X6 M S63 4.4L
E71 X6 xDrive35i N54 3.0L
E71 X6 xDrive35i N55 3.0L
E71 X6 xDrive50i N63 4.4L
Please make sure the OEM number matches the part you are replacing and compare with pictures provided here before purchasing